put your snowmachine on level ground. start your snowmachine and lower your idle to about 900. then loosen the bleeder bolt. lift your left ski up, then the rear, right ski, then the front of the snowmachine. check your coolant level. add when needed. keep up this procedure until your coolant level stops going down. the heat exchangers in the rear are higher than the coolant bottle. that's what my dealer told me. keep an eye on that bleeder bolt too, it could come off as the engine vibrates at low idle. when there seems to be no more bubbles, tighten the bleeder bolt. and check the heat exchangers. see if they are warm. if they're not, keep doing the procedure.
2003 Edge-X 800
Vforce 3 reeds, Powermadd Boost bottle, updated c.d.i. slp powder pro's, 1.25 predator track, fox racing clicker rear, rydefx center and skis, 1 in handle bar riser, specialty x can. 11.5 in cobra yellow tint windshield, and a sportech yellow tint lightshield.
