|
Polaris indy 650 rebuild and 600rr carb parts
started by wakeboarderboy
|
|
|
|
January 4th 2012 at 9:45 AM
[ Modified January 4th 2012 at 9:46 AM
]
|
|
| |
|
wakeboarderboy
Infinite Member
|
1980 Posts 
Group: Members
Member Since: January 21st 2009
Location: Drayton, Ontario, Canada
Current Sled: 2008 IQ 600RR
|
|
|
|
| |
Im going down to the shop to work on my sleds tonight and had a few questions.
There's a 92 Indy 650, mag side cylinder and pistons junk. 92 RXL 650 middle cylinders gone. Still ran just went slow home. Are the cylinders and everything the same? the RXL has low miles and is pretty mint so I'd like to get that one running and just use the one as a parts sled but I wasn't sure if the intake sizes and everything were the same. also what would have caused the rxl to burn up a piston? It was to the point where the plug had peices of piston in it when we stopped on the trail. And I don't really know how the efi works. And would I be better off using the carbs or the EFI?
2008 Polaris 600rr i need needles and seats is there any cheaper parts other than through polaris? just want to sell the sled. also I broke a clip going onto the carb it's a plastic plug with a couple wires coming off the end. It's the only electronic part on the carb.
Thanks!
|
|
 |
|
|
|
January 4th 2012 at 10:22 AM
|
|
| |
|
CWOENG
New Member
|
71 Posts 
Group: Members
Member Since: November 17th 2010
Location: North Yarmouth, Maine, USA
Current Sled: 2000 RMK 800
|
|
|
|
| |
Yes, the cylinders are the same. As far as the EFI/Carb question goes, there are very strong opinions on both sides of this, I have no opinion either way, they both have their good and bad. The RXL could have been a victom of E-10, snow in the airbox...etc. As far as your RR sounds like you broke the TPS connection.
2004 Pro-X 600
2001 XCSP 500
2001 XCSP 600
2003 Edge-X 700
1997 XC-600/RXL/RMK
|
|
|
|
|
|
January 5th 2012 at 10:17 AM
[ Modified January 5th 2012 at 10:17 AM
]
|
|
| |
|
|
wakeboarderboy
Infinite Member
|
1980 Posts
Group: Members
Member Since: January 21st 2009
Location: Drayton, Ontario, Canada
Current Sled: 2008 IQ 600RR
|
|
|
|
| |
what does the tps do?
And maybe I'll put the carbs in so I can sell the efi.
|
|
|
|
|
|
January 5th 2012 at 11:43 AM
|
|
| |
|
|
| |
throttle position sensor
I've never had a ten But I've had 5 two's
2003 Pro X
2008 IQR #44
2008 IQRR
2001 Edge X
1998 xc 700
1976 tx 340
1972 colt 340
1974 John Deere 400
1974 John Deere JDX Special
|
|
|
|
|
|
January 5th 2012 at 1:14 PM
|
|
| |
|
|
wakeboarderboy
Infinite Member
|
1980 Posts
Group: Members
Member Since: January 21st 2009
Location: Drayton, Ontario, Canada
Current Sled: 2008 IQ 600RR
|
|
|
|
| |
And I'm guessing the sled wont run without it?
|
|
|
|
|
0 user(s) are reading this topic (0 Members and
0 Guests)
