My 96 600 triple won’t run on all three cylinders. It has spark on all plugs and have swapped them to the middle which is the one without spark. I’ve swapped wires as well. It has 120-130 compression on all of them. It’s getting gas to the carb. Swapped the carb with the one next to it and...

So I have never done a piston swap and well I asked one of my friends and he told me to check the bottom end of the engine like crankshaft and all. But is it necessary? Because I want to only change pistons cause I know they´re bad. It is a hastle to remove all the plastics and everything to get...

Is it safe to use carb vent / fuel lines as the oil line? Both the oil and vent lines are 1/8th in size. Its on a 1994 Polaris XLT 580. Only thing Ive noticed is the original oil lines are slightly thicker clear (now yellow, hard, tarnished) lines than the new clear fuel line I bought today to...

All, The Yamaha Exciter Again. This is a 1987 but it must be a late 1987 as the 1987 manual does not show the heater grips as a option in the wiring diagrams. The 1988-1989 one does show the wiring for the grips and I have included it. The last thing I have to do before putting it back in the...

Hi folks, I know this is probably a topic that has been discussed many times, I am new to sledding relatively speaking, what are the benefits of switching to an Xtra 10 vs what I have now which is stock? Everyone I run into who says my 1994 XLT SKS looks great and they say to upgrade rear...