oil pump bleeding
Close
Login to Your Account
Snowmobile Fanatics - Snowmobile Forum - Powered by vBulletin

oil pump bleeding

This is a discussion on oil pump bleeding within the Polaris forums, part of the Brand Specific Snowmobile Discussion category; I have an 01 polaris xc 600 that I took the engine out of and rebuilt, I found that you are supposed to bleed the ...

"); }
Results 1 to 3 of 3

Thread: oil pump bleeding

  1. #1
    Junior Member
    This user has no status.
     

    Member #
    72000
    Join Date
    Nov 2019
    Posts
    2

    oil pump bleeding

    I have an 01 polaris xc 600 that I took the engine out of and rebuilt, I found that you are supposed to bleed the oil pump after air has entered the system. I have done everything I have read that im supposed to do but oil is still not getting to the oil lines that go into the carburetors. every other line has oil in them but those two. Any help/advice would be appreciated

  2. #2
    Senior Member
    This user has no status.
     
    greasemonkey's Avatar
    Member #
    10263
    Join Date
    Nov 2005
    Location
    Duluth Mn.
    Posts
    1,651
    1 quart of oil in the gas tank. Top off the oil tank and run it.
    Monitor the oil consumption in the oil tank. If it goes down than the oil system is purged.
    http://www.snowmobilefanatics.net/greasemonkey/2

  3. #3
    Junior Member
    This user has no status.
     

    Member #
    72000
    Join Date
    Nov 2019
    Posts
    2
    ok it took about an hour but the carbs finally seem to have oil going through the lines. tomorrow im going to mark the oil level and have it run for a while to make sure thanks

Remove Ads

Sponsored Links

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Search tags for this page

amazon

Click on a term to search for related topics.

Tags for this Thread