Search Results - Snowmobile Fanatics - Snowmobile Forum
Close
Login to Your Account
Snowmobile Fanatics - Snowmobile Forum - Powered by vBulletin

Search:

Type: Posts; User: bigwedgies

Page 1 of 20 1 2 3 4

Search: Search took 0.04 seconds.

  1. Replies
    1
    Views
    516

    Could have knocked the float out of adjustment...

    Could have knocked the float out of adjustment while you were cleaning.
    I'd recheck float height
  2. Replies
    21
    Views
    7,080

    Have you checked compression?

    Have you checked compression?
  3. Replies
    4
    Views
    1,133

    Will bolt right up no problems

    Will bolt right up no problems
  4. Replies
    4
    Views
    560

    Why are you boring it so far over for the first...

    Why are you boring it so far over for the first bore?
  5. Replies
    13
    Views
    5,153

    I'm confused, that's the pic with another 68...

    I'm confused, that's the pic with another 68 pitch put back in?
    With that gearing you should run a 66 as someone said, or find tej correct bottom gear
  6. Replies
    6
    Views
    1,086

    Tune up! Filters plugs good fuel. Maybe pull the...

    Tune up! Filters plugs good fuel. Maybe pull the carbs could be water or gunk in the bowls.
    But do this simple stuff first. Hard to diagnos a problem over the Internet, but it sounds like bad gas or...
  7. I would use the 97 bottom end if it were me. ...

    I would use the 97 bottom end if it were me.
    Also I would use the pipes from the 600. Don't write this in stone but if my memory serves me right, those pipes were the same as the ultra pipes in the...
  8. Replies
    5
    Views
    1,271

    Pulling to much air from somewhere of it runs...

    Pulling to much air from somewhere of it runs with choke on.
    Check your slide adjustments, one slide hung up maybe?
  9. Replies
    13
    Views
    5,153

    That's kinda where I was going. Looks like...

    That's kinda where I was going. Looks like someone swapped something in. Happens all the time with reverse stuff. People buy what's cheap, not the right stuff.
    Regardless something needs...
  10. Replies
    13
    Views
    5,153

    Did you just install the set up? That seems...

    Did you just install the set up? That seems seriously stretched.
  11. Replies
    6
    Views
    646

    What year is it? Could have been the water pump...

    What year is it? Could have been the water pump crapped out. Those were sealed to the crankcase and could have blown the deal.
  12. Replies
    5
    Views
    488

    Drive belt have a flat spot worn it it? Try...

    Drive belt have a flat spot worn it it? Try another belt
  13. Replies
    3
    Views
    483

    Fixed and heim

    Fixed and heim
  14. Replies
    10
    Views
    5,976

    Pm sent, I'm interested in the airbox

    Pm sent, I'm interested in the airbox
  15. Replies
    10
    Views
    5,976

    Good to know! Think I'm going to have to give it...

    Good to know!
    Think I'm going to have to give it a go, love my 05 edge, and I love my triples. Have enough prices and parts around I think I can do it relatively reasonably$$
  16. Replies
    10
    Views
    5,976

    That looks like the pipes fit very well!! That...

    That looks like the pipes fit very well!! That exactly what I needed to see. Did you build an engine plate? Or buy an already made?
    Thanks for the pics
  17. Replies
    10
    Views
    5,976

    Ultra triple in a 02 edge chassis

    Bought an 02 edge with a blown 800. Have always wanted to put one of my triples in one, and have a great 800 big bore itching to have something done with it.
    Question is how much trouble and I'm...
  18. Replies
    6
    Views
    643

    I'd have to agree, nothing like putting a clutch...

    I'd have to agree, nothing like putting a clutch on just in time for a rebuild.
    Why not just buy a new one? Or fix your old one? What failed on a clutch with 140 miles?
  19. 400 and 440 used the same bottom end as did the...

    400 and 440 used the same bottom end as did the fan and air cooled. Cylinders should be 44. All other models that year were points ignition. Tx had the Cdi.
  20. Replies
    2
    Views
    1,193

    Colt or tc 175

    Colt or tc
    175
  21. Replies
    19
    Views
    5,763

    When it will fail is not a good statement when...

    When it will fail is not a good statement when referring to snowmobiles or any power sports of that matter. Every sled will fail at sometime.
    As far as my comparison I'm just trying to say, how...
  22. Replies
    19
    Views
    5,763

    Some of the xlts did have crank problems, but...

    Some of the xlts did have crank problems, but having almost 5000 miles on the sled he originally posted about, it's either one that didn't experience the crank issue or it has already been repaired,...
  23. Replies
    19
    Views
    5,763

    All good sleds Don't be afraid of high miles,...

    All good sleds
    Don't be afraid of high miles, that just proves they have been a great sled.
    Also don't fear the triple. Kept in stock form they are great sleds. Yes a few had problems, but compare...
  24. Replies
    3
    Views
    708

    Never heard of any gains other then alot of...

    Never heard of any gains other then alot of noise. Most manufactures claimed 3-4 hp I think. If you have a set for 50 bucks might as well run them. But best money spent in clutching.
  25. Thread: 95 xlt 600

    by bigwedgies
    Replies
    9
    Views
    962

    Yes early 80s late 70s fugis were a deep bore,...

    Yes early 80s late 70s fugis were a deep bore, same with I know the centurion.
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4