Snowmobile Fanatics banner

1 - 6 of 6 Posts

·
Registered
Joined
·
9 Posts
Discussion Starter · #1 ·
Pulling the motor out of my 02 500XC, and dropping in a 600cc. Well, I've got everything disconnected, and the nuts are off the motor mount studs, but can't get it to wiggle out. Is there a trick to get it out? do I need to remove the mount studs on one side of the motor?
 

·
Registered
Joined
·
2,731 Posts
a long pry bar or another set of hands will get the job done.
 

·
Registered
Joined
·
918 Posts
You hafta unbolt the rear mounts from the bulkhead. Its a stupid deal but it will just lift out after that. Had to do that when I took out mine a couple weeks ago.
 

·
Registered
Joined
·
9 Posts
Discussion Starter · #6 ·
Dekk70 said:
You hafta unbolt the rear mounts from the bulkhead. Its a stupid deal but it will just lift out after that. Had to do that when I took out mine a couple weeks ago.
Thanks for all the replies, going to check on the torgue stop, and the rear mounts.
 
1 - 6 of 6 Posts
Top