Snowmobile Fanatics banner

1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
I have an 06 Fusion with a leak in the heat exchanger that is located in front of the track. I have the motor at a point that I was able to life it up enough to disconnect the hose to that heat exchanger on the right side of the sled. Does anyone know if I can remove this heat exchanger by removing the suspension , drive shaft and drilling out the rivets from the bottom side or do I need to completely remove the motor? This sled is enough of a PITA to work on that I do not want to do anymore dis-assembly then I need to. Thanks for any advise you can offer.
 
1 - 1 of 1 Posts
Top