[tbruch]

I just pulled my sled out to get it ready. It started up fine, but then I noticed that there is gas flowing out of the 2 open lines on one of the Mikuni carbs. I checked that spark plug for that cylinder and it appears that it is only running on the other cylinder.

Any ideas?

Thank you!

 

[ArcticStormRider66]

Take carb off and Clean it. Sounds like it is gummed up bad and Floats are sticking.

 

[daman]

Originally posted by ArcticStormRider66
[br]Take carb off and Clean it. Sounds like it is gummed up bad and Floats are sticking.

^^^ aaaa yup!!!

 

[stormrider62033]

could also be bad needle and seats but if you're lucky can clean them and will be fine

 

[tbruch]

Thanks folks. I found the tutorial on this site about cleaning those carbs, so I'll give it a shot. Any other hints on cleaning those or taking them out would be greatly appreciated!

 

[daman]

tear 'em right down use carb cleaner make sure all
passage ways are cleaned and blown out with shop air
check float height,etc,etc...

 

[lake357]

Where did you find that tutorial I think I have that same problem on my 1990 exciter?

Thank you