[Hotrod5332]

Ok, read alot of old post on this and found conflicting answers. What I have is a 95 xcr that I want to put a xtra 10 front and rear in. I know the back will fit but the front it throwing me for a loop. I made the mistake of buying the front suspension off of a 97 xcr and later found out reading info on this site that it is a crc front and will not work. So my questions are:

1. What can I use off of this front suspension?
2. What can I use off of my old sled, can I leave the trailing arm on?

 

[Bubbler]

Im not to sure about question #1 but question #2 I know this,you need traling arms from a sled with an xtra 10

 

[k2_huckdoll]

Im not to sure about question #1 but question #2 I know this,you need traling arms from a sled with an xtra 10

you need the radius rods from an Xtra 10 suspension, and shocks i used tie rods too). trailing arms are fine atleast they were on my XCR 440 136 x10 swap

 

[Polaris_Parts_MN]

I wouldn't suggest using the 8-inch trailing arms with everything else xtra10. xtra10 trailing arms hold the spindles at a different angle, correct for the proper geometry of xtra10.