Snowmobile Fanatics banner

1 - 2 of 2 Posts

·
Registered
Joined
·
36 Posts
Discussion Starter #1
Hi, change out all fluids on sled and put new throttle/ choke cables on and sync them. But when started pto carbs is not firing write . Took temp reading from pto side 75 , 185, 185 temp. Notice when taking carbs apart the jetting was wrong . Usually the pto side has the lower main . So from pto side it read 378, 378, 350. So I asked alit of questions about this so I put a 360 in the pto carb so now it's reads 360, 378 , 378. 40 pilots on all three. Can't get to fire write , have good spark in all three. Thanks for any Info.
and can I run two new double fuel pumps mikuni s



Sent from my iPhone using Tapatalk
 

·
Registered
Joined
·
15 Posts
one quick easy thing to check, is the float levers. its really easy if your not paying attention (guess how i know... lol) to put the float lever in upside down. which will allow a small amount of fuel to flow thru. maybe enough to idle. but will cut out as soon as you come off idle. just had this happen after a couple buddys were gonna "help me put my carbs back together" lol. hope this helps ya bud! :) good luck!
 
1 - 2 of 2 Posts
Top