Snowmobile Fanatics banner
1 - 4 of 4 Posts

·
Registered
Joined
·
109 Posts
Discussion Starter · #1 ·
looking to put a 2 pc edge or gen 2 seat on my gen 2 xcr 800 but the edge fuel tank doesn't allow room for the triple oil jug.has anyone done this sucessfully? i wonder if i could set up a different style oil jug above the chaincase? any info would be great. thank you
 

·
Registered
Joined
·
492 Posts
i havve got an edge seat for cheap.... but sorry cant help with the oil jug
 

·
Registered
Joined
·
521 Posts
You've got to change the rear coolers to get rid of the big hose that runs under the seat. The easiest way is to install a set of tunnel wear strip coolers from a gen II xc or XC sp. Then get the coolant/oil tank combo from the same sled and the hoses, and you should be good to go. I just used a thin piece of sheet aluminum over the big hole in the rear where the rear cooler used to be. Parts are pretty easy to find on ebay or from a salvage yard.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top