Snowmobile Fanatics banner

1 - 3 of 3 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1
I had an issue of no oil coming out of the oil tank to the pump. I now have oil to the pump, I premixed fuel and oil in the tank and ran the engine at idle while holding the pump wide open. Within a minute I had oil coming out the carb line on the pto side, but no oil on the other carb or the pto crank bearing line. Is this an indication of the pump being bad or do I need to run it longer for the other 2 lines to prime?
 

·
Registered
Joined
·
2 Posts
Discussion Starter #2
Figured I pop in and say all is good now. Cracked the bleeder on the pump and made sure oil was in the pump, then dropped a little oil down the cylinder for lube. After about 100 to 150 pulls of the rope, the lines primed up.
 
1 - 3 of 3 Posts
Top