Snowmobile Fanatics banner
1 - 4 of 4 Posts

·
Registered
Joined
·
12 Posts
Discussion Starter · #1 ·
Hi - last ride of the year last year I seized up the bottom end of my Utra. I had four bearings replaced, crank put back in phase, and replaced a piston (scores on the skirt.) I just finished putting the engine back in the sled but now I have no spark. I checked the plug at the stator and two of the 6 wires in the block have power when I pull the sled over. I have yet to check resistance readings. Could I have a problem with my cdi box or did I maybe not hook up a wire, ie. ground wire, or ? I don't recall if I plugged in the black wire for the key, kill, etc. but if I didn't do that then this shouldn't be my problem. Any ideas? Thanks everyone.
 

·
Registered
Joined
·
12 Posts
Discussion Starter · #3 ·
As for the grounds for the coil, there are two connections that I put underneath two of the bolts that hold the cooling rail over the heads. Could there be a problem with these?
 
1 - 4 of 4 Posts
Top