Snowmobile Fanatics banner
1 - 20 of 112 Posts

·
Registered
Joined
·
273 Posts
Discussion Starter · #1 ·
Well I decided to tear apart my 2002 RMK 700. My list of new parts are this: carbon fiber hood, Van Amburg wide running boards, koso egt, RSI bars, RSI riser, RSI hand guards, PSI dial-a-dome heads, Boondocker nitrous kit, boss seat, and powder coating varios parts.
Vehicle Bumper Snowmobile Car Automotive exterior
Before, with trailing arms removed for powder coat.
Automotive exterior Bumper Auto part Vehicle

Before, rear skid removed.
Auto part Engine Bumper
Van Amburg wide running board kit.

Carbon fiber hood, still needs to be painted black Vehicle Water transportation Boat Boating Watercraft

RSI bars and risers. Engine Auto part Vehicle Car Automotive engine part
 

·
Registered
Joined
·
622 Posts
Looks hot man cannot wait to see the final product. Where did you find the hood at?
 

·
Registered
Joined
·
273 Posts
Discussion Starter · #6 ·
polarisripper28 said:
if u dont mind me asking how much was it. u gonna put a light back in it?
I got it for 200, there are some minor spider web cracks that I'm fixing. Head light is not going back in, I'm mounting fog lights at the front of the nose behind the hood. I'll cut 2 holes and mount them recessed in the hood.
 

·
Registered
Joined
·
1,237 Posts
do you remove your old running boards to install the kit? one my running boards is twisted down about an inch and i cant bend it stright, if that could would replace it completly i would be alright
 

·
Registered
Joined
·
273 Posts
Discussion Starter · #8 ·
dodgetruck2 said:
do you remove your old running boards to install the kit? one my running boards is twisted down about an inch and i cant bend it stright, if that could would replace it completly i would be alright
Yes you cut off the existing and rivet on the new one. Check out the web site, van amburg enterprises.
 

·
Registered
Joined
·
1,237 Posts
great thanks, looks good, cant wait to see the final product
 

·
Registered
Joined
·
273 Posts
Discussion Starter · #11 ·
A little more progress today. Finished the running boards, and got the rear skid parts back from powder coat. Reassembled the rear skid and installed it. Also got the head off so I can install the PSI ead tomorrow. Bumper Auto part Wire Vehicle Automotive exterior

Compound bow Vehicle Musical instrument Tire Wheel

Auto part Engine Fuel line Vehicle Carburetor

Auto part Engine Vehicle Car Fuel line
 

·
Registered
Joined
·
273 Posts
Discussion Starter · #13 ·
Finished a bit more today; got the head on, and new plug wires, also mounted the koso egt and wired it in. Started on the boondocker kit, but got stuck, they're install instructions and my sled seem to be different. I'll have to call them tomorrow.
Auto part Engine Vehicle Automotive engine part Automotive exterior

Auto part Vehicle Engine Gas Car

Electronics Vehicle Technology Auto part Electronic device
 

·
Registered
Joined
·
584 Posts
your using the stock shocks?? or will you be putting some better ones in?
 
1 - 20 of 112 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top