Snowmobile Fanatics banner
1 - 1 of 1 Posts

·
Registered
Joined
·
109 Posts
Discussion Starter · #1 ·
This is the first engine I've ripped open. Can anyone tell me what would cause the five bearings on the crank to go? Two of them still have a partial nylon/plastic bearing separator in them and the other three don't have anything but the bearings. Now that I've replaced the bearings I was just trying to figure out why this happened and if it's going to happen again. I just bought this sled for my wife and the previous owners seemed to take good care of it, but when I took it out for it's first ride, obviously, the engine died. [EyeBall]
 
1 - 1 of 1 Posts
Top