Snowmobile Fanatics banner

1 - 9 of 9 Posts

·
Registered
Joined
·
46 Posts
Discussion Starter #1
gotat 95 xcr slp heads dg can new 3/4 track with 144 studs wondering what i could do for clucthing liek to keep my top end at 100 mph but would liek more snap off the line and for it to pull harder thorught the midrange i weigh 160 lbs
 

·
Registered
Joined
·
15,722 Posts
When I had mine I ran a blue secondary spring, T-1 helix, with a silver primary spring and If I remember right 47.5 weight. T-1 helix was a 42-36-34.
 

·
Registered
Joined
·
450 Posts
im running a white epi primary, 47.5 g weights, epi progressive quad angle 42-40-38-36, hot seat white secondary spring in hole 2. this setup gets me out of the hole faster than just about any stock 500 600 etc. with just a .82 lug track.
 

·
Registered
Joined
·
15,722 Posts
Not on mine as it was a 95 xcr 600.
 

·
Registered
Joined
·
2,109 Posts
10m-5 weights 49.5 g., HSP white primary, Helix can go with R8, T1, or 42-34 prog. HSP white secondary #2 or #3, & 20-39 gears. I dropped one size on the nozzles (needle jet) & one size on the mains. Gutted the air box except for the plastic shelf. It should spin @ 8500 +/-. A buddy of mine just sold this sled to another buddy of ours. Sled is going on its 13th season and still runs very strong. Pic of my old 95 XCR 6 from trip with the boys last Feb. 144 studs was more than enough. I went with 120 all in the center belt .
[attachment=51416]
 

Attachments

·
Registered
Joined
·
1,318 Posts
Nice sleds, my G/f has a 95 were in the process of pimping(pinking) out. I can look what her clutching is when I get the chance.
 

·
Registered
Joined
·
8,842 Posts
I have a good setup for them sleds.
 

·
Registered
Joined
·
4,541 Posts
madcow, how close is xcr 440 to your setup I have almost the same setup in my 600 and it is spinning 9500 rpms any suggestions.[?]
 
1 - 9 of 9 Posts
Top