Snowmobile Fanatics banner

1 - 9 of 9 Posts

·
Registered
Joined
·
17 Posts
Discussion Starter #1
Ok so I've removed my oil pump shaft and put the oil pump back on to fill the hole I pre mix my gas so far it's been fine so far rode 3 weekends no problems just wanted to check with other ultra owners to see what you know give me a little imput on this pls thanks
 

·
Registered
Joined
·
17 Posts
Discussion Starter #3
Ok so when I bought the sled the center cylinder was seized bad so I replaced it and decided to mix my fuel so I knew for sure that everything is getting oil
 

·
Registered
Joined
·
15,722 Posts
Does it have to oil line to the pto bearing??
 

·
Registered
Joined
·
8,842 Posts
you plugged or capped off the fitting at the carb flange right?!
 
1 - 9 of 9 Posts
Top