Snowmobile Fanatics banner

1 - 7 of 7 Posts

·
Registered
Joined
·
215 Posts
Discussion Starter · #1 ·
I have an EPI white secondary spring and i was wondering which hole it should be in. I dont want to lose to much top end either. I have an EPI orange primary. Which hole should my secondary be in?
 

·
Registered
Joined
·
215 Posts
Discussion Starter · #6 ·
Alright i figured out a good setup and why i was loosing top end. I went back to the stock sec. spring and wound it to the 4th hole. Also i decided to check my belt wear, even though it was just bought last year, and it as like .95in. Not even an inch wide. I am fairly certain that it should be wider but how wide should they be? 1 1/8? 1 3/8? Also i am going to check the clutch alignment today. How exactly do i do that???
 

·
Registered
Joined
·
88 Posts
clutch alignmet tool from polaris. if your belt is wearing it could be out of allignmet or too tight. add shims to your secondary and/or check the buttons.
 
1 - 7 of 7 Posts
Top