Snowmobile Fanatics banner

1 - 3 of 3 Posts

·
Registered
Joined
·
67 Posts
Discussion Starter · #1 ·
so i had to pull the motor out to put a new heat exchanger in, the engine is out i just bought a compression tester cause it might need rings can i do this still with the engine out and just pull it over a couple times what should the psi be on a 98 xcr 700??? any help would be great..
 

·
Super Moderator
Joined
·
11,279 Posts
You need to pull it over fast so someone might have to hold the motor or somehow keep it from moving while pulling the rope. Pull it over a strong 3-4 times and do it the same on all cylinders. Most polaris sleds are 120-125psi,im guessing the xcr 700 will be the same. As long as they are all within 10psi of each other you have nothing to worry about.
 
1 - 3 of 3 Posts
Top