Snowmobile Fanatics banner

1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
I had a stud rip out and punture my front heat exchanger(two small pin holes along the groove. Got it shut down in time. Can this be aluminum welded as it looks like quite a process to replace being part of the chassis. My son suggested jb weld?? What do you think?
 

·
Registered
Joined
·
128 Posts
Yah that would work did it on freinds sled(well he did it) I think it was the industrial kind made by Jb , that would be the best.
 
1 - 2 of 2 Posts
Top