Snowmobile Fanatics banner
1 - 4 of 4 Posts

· Registered
Joined
·
1,264 Posts
Discussion Starter · #1 ·
So I am putting a BMP stage 2 clutch kit on my 2010 F6 and I had a question about the primary and secondary. On the primary clutch, what size is the torx bolt? I think it's around a T-50 but I need to know exactly. About the secondary, I pulled it off and im wondering what the process is for taking it apart. Do I take out the 9 Torx screws in the front of the clutch or....? Will there be a lot of tension when I uninstall/install the sheaves? Thanks
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top