Snowmobile Fanatics banner

1 - 3 of 3 Posts

·
Registered
Joined
·
137 Posts
Discussion Starter · #1 ·
I cleaned both my carbs and now I can't find any info on how far out the air screw should be to start tuning my carbs. One carb had the screw out four turns and the other was only two turns. My manual said to look in the specs page but then it sais N/A for that setting. Does anyone have any tips for tuning my carbs? Mikuni VM30 mm. Thanks
 

·
Registered
Joined
·
393 Posts
If its the small air screw usually 1 1/2 to 2 turns out.should be close.Make sure you sync the carbs as well.Once you get it running you can fine tune the airscrew once it warms up.
 

·
Registered
Joined
·
137 Posts
Discussion Starter · #3 ·
Sync the carbs eh? I've been trying to read up on that. I'm going to go get one of those gauges for this and try to figure it out. Thanks for your help.
 
1 - 3 of 3 Posts
Top