Snowmobile Fanatics banner
1 - 3 of 3 Posts

· Registered
Joined
·
67 Posts
Discussion Starter · #1 ·
so im pulling the engine on my 98 polaris xcr 700 its goin pretty good not as bad as i thought i was wondering sumthings i should do and check while everything was apart i was gonna clean the snot out of everything and replace the things that don't look so if u have any good ideas let me know thanx
 

· Registered
Joined
·
9,987 Posts
Yes, check all the steering linkages.. The rod ends and bushings get pretty neglected.
 

· Registered
Joined
·
2,738 Posts
grease the steering post. there is a zerk in there that is impossible to reach when the motor is installed.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top