Snowmobile Fanatics banner

1 - 3 of 3 Posts

·
Registered
Joined
·
98 Posts
Discussion Starter · #1 ·
In the process of rebuilding me sled, got the new top end all done last night, everything looks good but before put antifreeze in it, I was wondering is there a specific proceedure to follow. I have to pick up the front end to burp it right? How else do I get all the air bubbles out.. thx again
 

·
Registered
Joined
·
2,655 Posts
There is usually a bleeder on the thermostat housing and there may be one at the rear of the sled under the seat...not sure about the xcr's. Jack the front up and keep filling and squeezing the hoses to get the air to move through. It sounds like you are ready. Good luck.
 
1 - 3 of 3 Posts
Top