Snowmobile Fanatics banner
1 - 6 of 6 Posts

·
Registered
Joined
·
172 Posts
I just put a 1" lug on mine seems a little close to the tunnel protectors but still lots of room at the front heat exchanger. 1" camoplast track no studs.
 

·
Registered
Joined
·
2,257 Posts
I'm ran a 1.25 ripsaw with the xtra-12 in my xlt before the skid swap and it cleared the tunnel after I notched it for the tunnel protectors. I did have scratches from the studs. Nothing deep. If your not using studs and without tunnel protectors, a 1.25 track will fit. I wouldn't go taller.
 

·
Registered
Joined
·
347 Posts
My buddy had a 1.25 Camoplast Predator on his 96 XLT with an Xtra 12 last year and it fit without any mods.

This year he put on a 1.75, went down to 8 tooth drivers and took his tunnel protectors off.

Hope that helps.

Spence
 

·
Registered
Joined
·
2,916 Posts
Protectors hit with a 1.5", not by much, took them off, could go to 1.75...maybe...
 
1 - 6 of 6 Posts
Top