Snowmobile Fanatics banner

1 - 4 of 4 Posts

·
Registered
Joined
·
343 Posts
Discussion Starter #1
the clutch plate where the spring is attached to wont go back on, it wont line up with the bolts. can someone help
 

·
Registered
Joined
·
2,016 Posts
If your talking about the front clutch, you have to re-intalled it at the same place it was before removal. The 2 pieces are balanced together!
 

·
Registered
Joined
·
844 Posts
If you are referring to the secondary, throw a roll of duct tape on the floor. place the clutch on it, twist the cover to the right until the holes line up with the studs,push down, install nuts.
 
1 - 4 of 4 Posts
Top