Snowmobile Fanatics banner

1 - 3 of 3 Posts

·
Registered
Joined
·
24 Posts
Discussion Starter #1
To start off I have an 02 RMK 700 ves, my secondary clutch blew up and I am trying to replace/repair it. It was the stock style with a goodwin roller half and the stock r8 helix and spring. Right now I bolted on my buddies old clutch from an 02 xc 600 to be able to move it. This clutch uses the same spring but a r11 helix. My question is am I going to have problems using this clutch on my 700? I really liked the way my old setup worked so I will probably go back to it eventually. Will this hurt my top speed or acceleration? Thanks.

the r8 has 50/34 angles and
the r11 has 45/36 angles

What does this affect?
Sorry for all the questions im new to clutches.
 

·
Registered
Joined
·
8,842 Posts
should be close enough to get your sled home. basically test your wide open rpms. they should be close.
 

·
Registered
Joined
·
855 Posts
your just not going to get the power out of the hole that you had with you other set-up, you will prob have great mid/top power though
 
1 - 3 of 3 Posts
Top