Snowmobile Fanatics banner

1 - 2 of 2 Posts

·
Registered
Joined
·
12 Posts
Discussion Starter #1
I have a 96 zrt 600 all stock except for some picks. Engine is fresh, carbs clean, new carb boots, 125pso compression cold.

Currently the stock setup is engaging around 4000-4100ish. Looking to raise the clutch engagement closer to 5000 rpms To hopefully over come a slight low end bog these 600 trips have. Every one I’ve ever rode has had it. Lol.

Currently has stock cat springs in primary and secondary. Seems I’m not getting a full shift either when I pin it, I’ve only been able to get it up to about 7700 rpm. I’m thinking it has something to do with my fat 300lb ass sitting in it lol.

Any clutching or spring suggestions thatwould help me out would be appreciated!

take care,

dan
 
1 - 2 of 2 Posts
Top