Snowmobile Fanatics banner

1 - 7 of 7 Posts

·
Registered
Joined
·
14 Posts
Discussion Starter #1
Bolt snapped off of driveshaft gear, floated around and cracked and bent casing at gasket edge. Anyone try to straighten cast aluminum casing?
 

·
Registered
Joined
·
14 Posts
Discussion Starter #5
Thanks for reply whitexc. Tried repairing cut a wood block to radius of case and pulled bent crack slowly with a c clamp while heating with torch. Lined up perfectly. Grooved crack and gasket surface with dremel then filled crack with jet weld. Filed gasket surface flush, new bearings, seals, gasket, used chain, working great. Total $80.00
 
1 - 7 of 7 Posts
Top