Snowmobile Fanatics banner

1 - 4 of 4 Posts

·
Registered
Joined
·
220 Posts
Discussion Starter · #1 ·
These photos are from a polaris 488.I bought the crank and case seperately. I think the crank is the narrow bearing variety and the case for a wide bearing.
I'm thinking there are pins in the bearing races that should drop into predrilled holes in the bottom of the case, which they dont.
 

·
Registered
Joined
·
220 Posts
Discussion Starter · #2 ·
bluevoyageur said:
These photos are from a polaris 488.I bought the crank and case seperately. I think the crank is the narrow bearing variety and the case for a wide bearing.
I'm thinking there are pins in the bearing races that should drop into predrilled holes in the bottom of the case, which they dont.
Also, Can I get a rebuild kit to make it fit and be right?
 

·
Registered
Joined
·
1,525 Posts
Can you get a picture of these bearing braces you're talking about? And less blurry, it's tough to see the full size photo.

Have you tried the fit with the crank seal in place?
 

·
Registered
Joined
·
707 Posts
i just put my crank in and the pins in the bearings go into little slots right on top where the cases meet but that was mine im not too sure about yours also i had two bearings on my clutch side but once again different sleds may be different
 
1 - 4 of 4 Posts
Top