These photos are from a polaris 488.I bought the crank and case seperately. I think the crank is the narrow bearing variety and the case for a wide bearing.
I'm thinking there are pins in the bearing races that should drop into predrilled holes in the bottom of the case, which they dont.
These photos are from a polaris 488.I bought the crank and case seperately. I think the crank is the narrow bearing variety and the case for a wide bearing.
I'm thinking there are pins in the bearing races that should drop into predrilled holes in the bottom of the case, which they dont.
Also, Can I get a rebuild kit to make it fit and be right?
i just put my crank in and the pins in the bearings go into little slots right on top where the cases meet but that was mine im not too sure about yours also i had two bearings on my clutch side but once again different sleds may be different
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Related Threads
?
?
?
?
?
Snowmobile Fanatics
1.3M posts
60.7K members
Since 2001
A forum community dedicated to snowmobile owners and enthusiasts. Come join the discussion about performance, racing, troubleshooting, trails, maintenance, riding tips, modifications, classifieds, gear, and more!