Snowmobile Fanatics banner

1 - 2 of 2 Posts

·
Registered
Joined
·
116 Posts
Discussion Starter #1
Hi guys, I just got my crank, bearings, and pistons done. I run a oil injected sled. What is the proper way to break this motor in now? Do I pre-mix my first tank? What about RPM's? How much of what is needed?
Thanks.
 

·
Registered
Joined
·
837 Posts
i think you put about 3/4 quart in and ride like normal, take it a little easy on the first runs then you should be good just don't hold it wide open for long
 
1 - 2 of 2 Posts
Top