Snowmobile Fanatics banner
1 - 2 of 2 Posts

·
Registered
Joined
·
38 Posts
Discussion Starter · #1 ·
I've got a free edge seat that is sitting in the garage, and a '93 indy 500 with a ripped seat. They look close in dimensions.

Can it be done?
 

·
Registered
Joined
·
4,331 Posts
if you use an edge tank you can here is a topic i started

http://www.snowmobilefanatics.com/forum/topic.asp?TOPIC_ID=59131

this is what i was told i had to do by sleddyeddy remove old gas tank and seat, there is a metal plate on the bulk head i just bent it down to clear the gas line, slide it up as far as possible, fits in really good, then remove the rear bumper, put the seat on my holes for the bolts were diff had to drill new holes, and that was it, make sure its pushed up close to the tank, bolt the seat on i didnt even need to bolt down the gast tank, it never moved at all. and i ride hard. the rear bumper i had to angle it upwards about an inch to clear the seat thats it.
 
1 - 2 of 2 Posts
Top