Snowmobile Fanatics banner

1 - 4 of 4 Posts

·
Registered
Joined
·
3,040 Posts
Discussion Starter #1
I am almost done putting the pipes back together but on the end of the pipe, where it connects to the box there's a fitting, it has what looks like steel wool (it's only on about 1/4 of the piece) does it matter what direction it goes in, and do I put sealer on the box.
 

·
Registered
Joined
·
5,686 Posts
I would put some of the Permatex ulra copper on the fittings for a good seal. About that piece I'll ask a friend tomorrow and post then.
 

·
Registered
Joined
·
699 Posts
i bought some high heat red rtv silicone sealent for my exhaust because i was gettin leaks around where my manifold connected to my pipe that did wonders and it is fairly cheap they sell it at automotive shops every where and probaly hard where stores
 

·
Registered
Joined
·
3,040 Posts
Discussion Starter #4
So I should put sealer everywhere, and does it matter if some gets inside.
 
1 - 4 of 4 Posts
Top