Snowmobile Fanatics banner
1 - 4 of 4 Posts

·
Registered
Joined
·
181 Posts
Discussion Starter · #1 ·
Ya ya, I know...post is worthless without pics...... Will post shortly..

I have a quick question......

One of my Polaris 440 Exhaust pipes is cracked at the flared section where it connects to the "Y" pipe. Do you guys just have local muffler shops weld it up and/or weld on a new nipple? or do you take them somewhere else?

Since it's the stock pipe, it's steel...so no fancy brass welds are needed like on some of the higher end pipes. Oh and I suck at welding thin steel. [:D]

Thanks !
 

·
Registered
Joined
·
1,969 Posts
should be an easy weld/fix. post pics when you get em!
 

·
Registered
Joined
·
546 Posts
There is alomost like a puddy product that can seal cracks and holes, I've had a couple friends use it and it has been fine but it was only on summer toys so i dont know about the colder temps, I would imagine it wouldn't matter cuz it heats up anyways.
 

·
Registered
Joined
·
1,898 Posts
sounds easy and i no sum of them are 1/8 thick so its real easy to weld even if its a 1/16 its not bad.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top