Snowmobile Fanatics banner

1 - 5 of 5 Posts

·
Registered
Joined
·
6 Posts
Discussion Starter #1
I have a Polaris 2003 RMK and I am going to purchase Fly Areo Tappered Handlebars with a 3" riser and pivot with throttle and brake extensions and was wondering if anyone could tell me if i need to do anything with the electical cables?
 

·
Registered
Joined
·
1,350 Posts
You should have enough wires to do that. I just put 8.5" on my RMK and had to move the wires to the front pull out the slack and ended up extending 4 of them. I also did it without a throttle extension and added hard line to my existing brake cable to make it reach!!

DW
 

·
Registered
Joined
·
6 Posts
Discussion Starter #3
Ok that makes me feel better i just ordered all my stuff yesterday so it should be her hopefully tomorrow. I will post some pics of mine when its finshed. I checked out your pics and its looks sweet. My dad has that same sled only and 800.
 

·
Registered
Joined
·
6,044 Posts
With only a 3" rise, you should be OK with your wiring.
You've got the throttle and brake extensions, so you are good there.
You will also be looking at new hand warmer pads if you don't already have a set.
They just don't like to peel off the bars and still work.

With that, you should be fine.
 

·
Registered
Joined
·
6 Posts
Discussion Starter #5
Yea I ordered some handwarmers also and with the Fly MiniBend Bars where they are aluminum do the warmers work as well? Is everything easy to install?
 
1 - 5 of 5 Posts
Top