Snowmobile Fanatics banner
1 - 4 of 4 Posts

· Registered
Joined
·
118 Posts
Discussion Starter · #1 ·
so i wanto go from a 121 track to a 144 if i use 7 or 8 tooth drivers i shouldnt have to gear down should i? i have 9 tooth now
 

· Registered
Joined
·
147 Posts
ULTRArmk said:
so i wanto go from a 121 track to a 144 if i use 7 or 8 tooth drivers i shouldnt have to gear down should i? i have 9 tooth now
what size track are u trying to turn? lug height? motor size??


i have a 99 xc 600 141" with a 2" paddle. that i went from 9 tooth down to 7 tooth drivers(had to to clear the front cooler), and then switched the stock gearing from 22/40 to 20/41. doesnt have top end, but as lots of low end.

hope it helps
 

· Registered
Joined
·
118 Posts
Discussion Starter · #4 ·
well i have a 96 ultra but i just looked at 2000 xcr 800 i think ima buy! so a whole new project
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top