Snowmobile Fanatics banner

1 - 4 of 4 Posts

·
Registered
Joined
·
1,046 Posts
Discussion Starter #1
Has anyone out there put an ultra motor into a wedge style xc chassis with the rack style steering? I'm trying to help my friend out with his rolled case mistake. We have a complete 97 xc 600, minus the motor, that we can use to keep him going if the ultra motor will fit into it. Any info based on first hand experience would be appreciated.
 

·
Registered
Joined
·
1,630 Posts
I put a 89 650 motor into a 98 xcr 440 chassis if that tells you anything. Wasnt that hard. Getting the coolant and oil bottles sorted out was the biggest headache. Had to chop up a nice set of tripple pipes in several locations to get them to fit but even that was only a couple hour job. Depending on where the coolant lines end up, the ultra motor might be easier. Good luck with whatever you do.
 

·
Registered
Joined
·
586 Posts
they made an ultra in a wedge chassis so im sure it would fit. your chassis was set up for a twin so im sure you'll have to change the mounts but it shouldnt be too aweful hard to get it in there.
 

·
Registered
Joined
·
137 Posts
I would think the hardest part is going to be aligning the clutches.
 
1 - 4 of 4 Posts
Top