Snowmobile Fanatics banner
1 - 5 of 5 Posts

·
Registered
Joined
·
324 Posts
Discussion Starter · #1 ·
She finally started, But when I take her out the temp light comes on once in a while. Is this normal on a rebuild? She is also a little boggy. Once in a while she would not get past 2000 rpm when yoiu gased it. Then you could feather it and after the rpm hit 3000 it was fine. Almost sounded as if was flooding. I cleaned the carbs, but the needle and seats havae not been touched in about 3 years. Could that lead to the water temp problem? I do have a EGT and head temp sensor and every thing looks great there. Any ideas?
 

·
Registered
Joined
·
324 Posts
Discussion Starter · #4 ·
BTW the temp was about 42 outside and the snow is slush. I think there was enough snow on the exchangers. Any chance that snow just wasn't able to cool being heavy and wet. I never run the sled much over 30 deg. The sled is jetted for 0
 
1 - 5 of 5 Posts
Top