Snowmobile Fanatics banner

1 - 6 of 6 Posts

·
Registered
Joined
·
36 Posts
Discussion Starter · #1 ·
I have a 97 vmax 600 I just ran it today and I saw a drip of coolent come out of one of the studs of the head I dont know what to do or is this a bad thing. Please help me.

Justin Jarmus
 

·
Registered
Joined
·
287 Posts
Is that bolt loose?? Are all the head bolts tight? You might want to make sure, Justin. Not sure what the torque spec is for your motor, either... Anyone??

1998 Arctic Cat Cougar
1999 Arctic Cat Z 440
1995 Ski Doo Formula STX LT
 

·
Registered
Joined
·
36 Posts
Discussion Starter · #3 ·
I did and there is still coolent going tru it so I have a feeling that I have a big problem. I have no clue on the spec of it but if anyone does please let me know thank ACMAN but there all tight so I know it not just loose .

Justin Jarmus
 

·
Registered
Joined
·
88 Posts
i had a yamaha 570 and i noticed when cleaning the engine that there was permatex on the head bolts.does that sound right?
 

·
Registered
Joined
·
3,063 Posts
begin by torquing the bolts to the correct value, if that doesn't help buy a new head gasket and replace it. It's less than a 20 minute job.

Win if you can...
Loose if you must...
But NEVER stop trying!
 
1 - 6 of 6 Posts
Top