Snowmobile Fanatics banner
1 - 3 of 3 Posts

· Registered
Joined
·
413 Posts
Discussion Starter · #1 ·
I'm rebuilding my father in laws 1997 formula III triple top end, (after him seizing the engine) with new pistons...and i'm wondering about what the correct torque is for the head bolts? Gonna put it together tomorrow..[thumb]
 

· Registered
Joined
·
413 Posts
Discussion Starter · #3 ·
I found the answer myself, the headstuds needs 30nm and the cylinder base studs needs 29nm.. the engine is now mounted together..
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top