[kipper]

I have an 03 Edge 700. I have recently put on a mbrp race can and v-force 3 reeds. When the sled gets into the high rmp's (6500+) the sled just bogs and stays there, also it doesnt idle hardly at all. It will drop to about 200-400 and then just die out. I cant remember what it use to rev to but I believe it was about 7500 or 7700. What could the problem be? Dirty carbs, Bad gas, Need to rejet? Thanks

 

[ProRacer]

needs to be jetted most likly and tuned

 

[PolarisEdge]

Originally posted by ProRacer
[br]needs to be jetted most likly and tuned

Sounds like a jetting issue for sure.... I wouldn't try to run it like that or you will most likley burn it down.

 

[kipper]

ok what should the plugs look like?

 

[Bobinwi]

plugs should be cardboard brown in color with correct jetting

 

[Blackcat]

^ after you run it WOT for 1/2-1 mile or wrapped up pretty good for 30-45 seconds on a stand.

If you let it idle and then pull them, they will be wet and black every time.

 

[X-Treme3x]

I cannot see any jetting cause it not to pull top rpm. Perhaps once you do what others recomend check your VES and make sure they are clean and the hole in the cylinder is not plugged either.

 

[kipper]

Well I checked the plugs after taking it for a short ride around the yard, and they were the golden brown that you were talking about. So I will check the VES and see if that is the problem. Also I bought all the things off a guy with and RMK 600 and he never had jetted at all, so that leads me to think its something else.

 

[Luke]

Are you sure the 600 can is the right one for your 700. That can really f'things up if it dosnt flow enough for your bigger engine.
However, aside from the can, It really sould like a jetting or fuel delivery issue. Or possibly the ves.

Good Luck

 

[polaris4u1]

i had the same problem with my buddies 700. it turned out that thecarbs were bad. it was just a little bog at first and by the end r the month it was dumb. we ut a new set of carbs on it and it whent like hell again and we tried his carbs an another 700 and it bogged

 

[kipper]

Ok well I will clean out the carbs real good tommorow and see if that make a diffrence. If not ill check the VES out again.

 

[kessinger700RMK]

I put v force in my sled and didnt rejet,and it ran fine still.

 

[X-Treme3x]

Originally posted by kipper
[br]Ok well I will clean out the carbs real good tommorow and see if that make a diffrence. If not ill check the VES out again.

Make sure you airscrews are the same...I would think 1.5 turns out from lightly seated would be where you want them.