Snowmobile Fanatics banner

1 - 1 of 1 Posts

41 Posts
Discussion Starter #1
Hello all, I managed to get a hold of an ITS suspension that I would like to jam in my 1987 indy trail. Does anyone have an 93 XLT that they could measure hole locations from the flat of the drive shaft. I know this is not a very popular swap, but the suspension i got now needs o be replaced. I have searched far and wide for an answer an I can't find anything.

Any help would certainly be appreciated.

If i end up figuring it out on my own, I will post the measurements here.

Thank you.
1 - 1 of 1 Posts