Snowmobile Fanatics banner

1 - 8 of 8 Posts

·
Registered
Joined
·
5,400 Posts
Discussion Starter #1
Check this out, after talkin to my dealer, in which he told me he didn't have a press that could press the drivers off the drive shaft I decided to try my hand. This is what I came up with.

[attachment=49398]

[attachment=49399]

[attachment=49400]

Just throwing this out there.
 

Attachments

·
Registered
Joined
·
1,056 Posts
They go on much easier if you grease the shaft too.
 

·
Registered
Joined
·
3,888 Posts
Looks good 650! Now thats enginuety at work.
 

·
Registered
Joined
·
5,400 Posts
Discussion Starter #6
The design took me all of 5 sec the actual construction took 30 minutes. And now I've got an issue. I made the studs too short to reverse and use to press the new ones on. So I may just have my dad take it down to his work and see if their press is large enough.
 

·
Registered
Joined
·
1,658 Posts
Nice idea, the only concern I have is mild steel and mild threaded rods + hyd. jack = look out for flying steel !!! ( been there, done that )
 

·
Registered
Joined
·
5,400 Posts
Discussion Starter #8
Worked good, thanks for you concern though Greasemonkey. Someone cares.[;)]
 
1 - 8 of 8 Posts
Top