Snowmobile Fanatics banner

1 - 4 of 4 Posts

·
Registered
Joined
·
1,108 Posts
Discussion Starter · #1 ·
This is the last big thing i have to do on my sled. I cant think of a way to hook my carbs to the stock airbox and look good. I dont want to use pod filters, i want it to look stock. My carbs are about an inch from going into the box. I added a 3rd hole to the stock plate but the carbs are just to far away and dont slide into the boots, all i need is about an inch. Any ideas?

thanks

oh and heres a couple pics


View attachment 201091919751687_20985.bmp

View attachment 20109191975393_20985.bmp

View attachment 201091919754500_20985.bmp
 

·
Registered
Joined
·
1,555 Posts
take some pvc that will fit over the carb, a few hose clamps and there you go. I had pods when i had the storm motor in my sled and i had to take a 90 degree angle and a few short pieces of pvc to make them go verticle. thats my advice. just extending the carb boots a little i guess.
 

·
Registered
Joined
·
411 Posts
Use 2003 Pro X 440 Intake boots. They will work better than anything else because they have a lip on one side that will seal on the inside of the air box.
 

·
Registered
Joined
·
1,982 Posts
sTOrMy96 said:
take some pvc that will fit over the carb, a few hose clamps and there you go. I had pods when i had the storm motor in my sled and i had to take a 90 degree angle and a few short pieces of pvc to make them go verticle. thats my advice. just extending the carb boots a little i guess.
X2, Had a friend that did that.
 
1 - 4 of 4 Posts
Top