Snowmobile Fanatics banner

1 - 3 of 3 Posts

·
Registered
Joined
·
39 Posts
Discussion Starter #1
I am currently installing a fuel gauge on my 97 mxz 670 and was wondering where the sensor goes? Where do I cut the hole on the gas tank? The directions that come with the kit are garbage and I cant figure it out. I believe it goes where the seat touches the tank but would really like some other input possibly with pictures. Thanks,
Ryan
 

·
Registered
Joined
·
4,983 Posts
Did you look at a parts diagram? Fiche are available online.
http://www.inglesperformance.com/custompage.asp?pg=fiche

Or at the BRP website.
 

·
Registered
Joined
·
3,449 Posts
I don't have any pictures but you are correct. The mechanical part goes into the tank on the back of it (under the front part of the seat). Take your seat of and you should see a circle moulded into the tank roughly about the same size as the fuel sensor. That is where it will be located. I believe the wire's ran underneath the tank and up to the console also.
 
1 - 3 of 3 Posts
Top