Snowmobile Fanatics banner

1 - 2 of 2 Posts

·
Registered
Joined
·
193 Posts
Discussion Starter #1
I put my driveshaft in the chaincase with the track on, but left it off the clutch side because I needed a bearing. I bolted down the driveshaft and put on all the sprockets while it was hanging there...now when I tried to get the new bearing in on the clutch side, the driveshaft was at the bottom of the opening and now im worried all that weight of the track bent something in the chaincase...I got it all together with the help of a floor jack. Think Im ok or should I inspect the case?
 

·
Registered
Joined
·
1,969 Posts
if anything i'd be worried about that chaincase side bearing. it's unlikely that the case itself bent. the bearing could have turned in it's seat. i'd take that driveshaft back out and look at the bearing.
 
1 - 2 of 2 Posts
Top