Snowmobile Fanatics banner
1 - 8 of 8 Posts

·
Registered
Joined
·
161 Posts
Discussion Starter · #1 ·
Well i know that my key broke and now i need to replace it. And i need to replace the bearing. But i have no idea how to do it. I need someone to walk me through everything!
 

·
Registered
Joined
·
317 Posts
iv never don it on a cat, but on my yamaha i had to
open the chain case,and remove the gears and chain,
drop the track and rear suspention out
then unbolt the housing that holds the bearing,
then u should be able to slide the drive cog assembly out toward the chain case and then pull it the rest of the way out and the bearing should be on the end of the drive cog shaft. atleast thats how it was on my exciter
 

·
Registered
Joined
·
844 Posts
On the speedo drive side, there is a locking collar.
It may or may not have a set screw in it.
 

·
Registered
Joined
·
317 Posts
i think its pressed on, put the outside of the bearing in a vice, and tap out the shaft with a mallet, use a piece of pipe about the same size as the shaft so you dont dammage it,also spray it down with some penitrating oil to get any corrosion off. if that doesnt work, than have someone use a press and press it out
 
1 - 8 of 8 Posts
Top