Snowmobile Fanatics banner

1 - 3 of 3 Posts

·
Registered
Joined
·
95 Posts
Discussion Starter · #1 ·
ok i changed my throttle cable with a new one. I have to get one with 2 cables and a oil injection cable to. so my cable has three cables 2 for the carbs and one for the oil injection. my problems are is that i can get the snowmobile started but then it seems like its flooded while it idles. then you pump the gas a few times and it clears up. then i tried opening the whole throttle up of the snowmobile and it got to a certain rpm and then it poped and started runing on one sparkplug. so did i get some setting wrong or what else do i need to do? is there certain ways to set the cables. i can usually get it going but then after i get on it it starts popin and runing on 1 sometimes it clears up.

Thanks for all help
 

·
Registered
Joined
·
95 Posts
Discussion Starter · #3 ·
i adjusted it a little but maybe i dont have it in the right place yet. I also just put new plugs in it, so it sometimes fouls one out and then sometimes they both work. but sometimes screwed up. could be my sparkplugs but there only like 8 minutes on them.
 
1 - 3 of 3 Posts
Top