Snowmobile Fanatics banner

1 - 6 of 6 Posts

·
Registered
Joined
·
1,479 Posts
Discussion Starter · #1 ·
on my xc i have the slp twin pipes but for some reason they are really not sealing good they dont have a doughnut gasket they kinda have rings on them like a piston and thats where the oil is blowing back out on my motor can i use some high temp silicone between the pipe and the maybe called manifold..
 

·
Registered
Joined
·
1,958 Posts
Goop em up good, that's about all you can do, aside from ordering new seal rings from SLP, a lot of guys use red or black but I am a devoted fan of the Ultra Copper.
 

·
Registered
Joined
·
1,479 Posts
Discussion Starter · #3 ·
98700xc said:
Goop em up good, that's about all you can do, aside from ordering new seal rings from SLP, a lot of guys use red or black but I am a devoted fan of the Ultra Copper.
good deal and this is like a high temp silicone i can get from an autoparts
 

·
Registered
Joined
·
258 Posts
Nothing but permatex ultra copper all the way (item# 81878)101BR. I goop it up good, wet my finger and wipe/smooth. If you dont wet the ole finger it will remove all of what you just put on. Trust me..I do this a few times each season.
 
1 - 6 of 6 Posts
Top